Galvanized posts
Galvanized posts are basically used for chain link enclosures. However, although their use in knotted fencing is not that common, they can also be used as a clamping element on these enclosures.
Fast shipping
-
MenuBack
-
Mesh
-
-
Welded Mesh Panels
-
-
Fencing
-
-
Wires
-
-
Fence posts
-
-
Doors and gates
-
-
Puertas y cancelas
-
Puertas y Cancelas
-
-
-
Livestock equipment
-
-
Material ganadero
-
-
-
Enclosures
-
-
DIY Hardware
-
Galvanized posts
Filter By
Price
Price
-
€3.00 - €5.00
Height. (cm)
Height. (cm)
Direct shipments within 4 days
Showing 1 product
Active filters
- Post holes layout: 50T+3Ø ST de 2m+2Ø visera ST 1m
For chain link enclosures, generally, a starting multi-hole galvanized post is place at the start and end of each segment. Such starting post is used to place the guide wire in which then the mesh will be bonded. The guide wire will be tightened using galvanised tensioners also attached to the starting post.
Once the starting post in in place, galvanised intermediate posts should be installed. A distanced of 3 m between posts is recommended.
Such posts are available in galvanized and polyester powder coated finish.
With regards to the height of the posts used, it will always depend on the designated location of the enclosure. Posts should all have a minimum of 40 additional cm if crammed on ground. If, instead, they are installed on a smooth surface, they can have the same height of the chosen fencing. Generally, for this kind of installation, they have an anchor plate for floor mounting.
With the aim of reinforcing the fencing, a multi-hole intermediate post will be installed every 25 m. Such post will include a brace on each side and tensioners to tighten the guide wires.
Download fencing and enclosures catalogue